1. Good to know
a. Estimated savings: 17 €!
b. Duration: 20min
c. Difficulty: 1/4
2. Checklist of preparation
|· Universal pliers
3. It’s gone … hands in grease!
a. To access and replace the headlight bulbs it is necessary to open the trunk of the vehicle and take out all the headlight block. Open the chest and locate the plastic butterfly that holds the fire. With a universal clamp, unblock it, and finish the removal by hand.
b. The fire is maintained by plastic nipples fitted directly into the bodywork. With your hands, gently pull the alignment of the car over the fire to extract it.
c. Remove the power connectors. To do this, press on the small plastic tab, and simultaneously pull on the pod.
d. To remove the bulb holder plate, pull out each of the red plastic tabs that hold it while holding a pull on the turntable. Once unlocked, two small interior connectors are removed. Just pull on the pod.
e. To replace the bulbs, just press on them and rotate them a quarter turn to the left. They will come out alone thanks to a spring effect.
f. To get back the news, press the bulb and rotate it a quarter of a turn to the right.
g. Reconnect the two internal connectors on the board, then put the board back in the right direction, and simply by pressing it, the tabs will spread to let it pass and lock it once in place.
h. Reinsert the electrical connections in the fire.
i. Rest the fire in its place by pressing without forcing.
j. Screw on the butterfly and block it by hand or by the pliers.
k. Done !