* Issue : Contaminated Brake Linings* Description : When brake linings are contaminated with oil, grease, or brake fluid, braking will be uneven. The source of the leak should be properly identified, and pads and shoes will likely need replacement.* Solution : Brake Inspection * Issue : Incorrect Tire Pressure* Description : Tire pressure plays […]

* Issue : Brake Booster Problem* Description : A damaged diaphragm is a common reason for brake booster failure.* Solution : Brake Inspection * Issue : Leak in Vacuum* Description : The vacuum plays an important role in drawing air into your vehicle’s cylinders, as well as assisting in cruise control components and the emissions

* Issue : Air in Brake Hydraulic System* Description : Air may become trapped in the brake system through moisture that is absorbed by brake fluid, during a component failure, or during a service procedure. If too much air is trapped in the brake system, complete brake failure may occur.* Solution : Brake Inspection *

* Issue : Warped Brake Rotors* Description : Excessive heat or improper wheel lug nut torque may cause brake rotors to warp. Do you feel pulsation or vibration in the brake pedal ? It is necessary to check the rotors to ensure they are parallel, which means no variation in thickness. If the brake rotors

* Issue : Engine Oil Leak (Odor)* Description : Valve cover gaskets may begin to leak from normal wear and overheating of the engine. Most are constructed of rubber and others are cork. Excessive heating and cooling will eventually harden the materials and make them crack. Oil pressure and oil flow will leak out through

* Issue : Low Brake Fluid* Description : A system leak or worn brake pads may be the reason for low brake fluid. When the brake fluid indicator light comes on, it is important to have a brake safety inspection performed.* Solution : Rear Drum Brake Repair * Issue : Faulty Parking Brake Switch* Description

* Issue : Exhaust Manifold Gasket Leak* Description : The exhaust manifold carries the combusted gases from the engine to the exhaust. The exhaust manifold becomes extremely hot because of engine combustion. The constant heating and cooling of the exhaust manifold can cause it to crack or wear the gasket down over time causing it

* Issue : ABS System Fault* Description : If there is a fault in the ABS system, the vehicle will still brake, however there may be a loss of power-assist. This situation is very unsafe, and the faulty ABS system should be repaired immediately.* Solution : Brake Inspection

* Issue : Exhaust System Leak* Description : The constant heating and cooling of the exhaust manifold can cause leaks. You may catch a small crack before it becomes large enough to make a noise and become a more serious problem.* Solution : Exhaust Inspection

* Issue : Check Engine Light* Description : When your vehicle’s Check Engine Light comes on, it is important to seek service quickly to prevent damage to your engine.* Solution : Dashboard Warning Diagnostic